Description Give your NerdQaxe a proper home. This stand is custom designed for the NerdQaxe , securing the full board with four corner mounting posts that pass directly through the PCB’s mounting holes. The rear of the stand features a dedicated 80mm fan cutout, giving you a clean mounting point for supplemental cooling. Fastener points accept M10 screws so you can lock the fan down with confidence. The tiny gaps between the PCB and the stand keep airflow exhausting heat from the back of the board during long mining sessions. This stand was designed around the NerdQaxe form factor to solve that problem while keeping your setup looking professional. Printed from HT-PLA-GF (glass fiber reinforced high-temperature PLA) for added rigidity and heat resistance over standard PLA. Key Features Four corner mounting posts pass through the NerdQaxe PCB mounting holes to secure the board in place. 80mm rear fan cutout for mounting an exhaust fan directly behind the heatsink and rear PCB. M10 fastener points for secure attachment of the fan. Open-frame for unrestricted airflow. Wide, stable base with embossed Solo Satoshi branding. HT-PLA-GF construction (glass fiber reinforced, high-temperature PLA) for improved rigidity and heat tolerance over standard PLA. Angled display position for easy screen visibility and a cleaner desk layout. Compatibility Designed specifically for the NerdQaxe desktop Bitcoin solo miner. Four mounting posts align with the NerdQaxe PCB corner holes. Rear cutout sized for standard 80mm fans (fan not included). Accommodates standard and aftermarket heatsink configurations. Not intended for Bitaxe, NerdQaxe , or other form factors. For Bitaxe stands, see the AxeStand or the Black 3D Printed Bitaxe Display Stand. What’s Included 1x Black 3D printed NerdQaxe display stand. Not included: NerdQaxe miner, 80mm fan, M10 screws, power supply, or cables. Looking for the miner? Shop the NerdQaxe Rev 6.1 here. Setup Instructions Place the stand on a flat, stable surface. Align the four corner mounting posts with the NerdQaxe PCB mounting holes. Lower the board onto the posts until it seats flush against the stand frame. (Optional) Mount an 80mm fan into the rear cutout using M10 screws through the fastener points. Pair this stand with a Noctua NF-A8 80mm fan in the rear cutout for optimal exhaust cooling. Power your NerdQaxe with the Mean Well LRS-600-12 and follow our NerdQaxe Setup Guide for a complete walkthrough.
